Premier SP Floor Sealer


How Much do I need? +

*Single Coat depending on substrate


Fiddes Premier SP Floor Sealer is a high solid, water based 1 component self cross linking floor sealer/primer, for the surface treatment of wooden floors prior to the application of Fiddes Premier SP Floor Water Based Polyurethane.

Additional information

Weight 5 kg

Ensure all surfaces are clean, dry, and free from any previous finish. Fill any cracks/knots with Fiddes Floor Filler Gel where required. Sand the substrate with a fine 120/150 grade sanding paper or 120/150 grit sanding disk, removing all traces of dust.


Ensure all areas to be coated are extremely well ventilated during and after application. Always test on a small area prior to initial application. Maximum 2 coats recommended. Apply at room temperature. Fiddes SP Floor Sealer is formulated for application directly, and does not require thinning.

First Coat

Stir contents thoroughly before and during use, and apply in a warm, well ventilated room. Apply THINLY using Fiddes Floor Oil Brush or a good quality bristle or synthetic brush, and lay EVENLY, following the direction of the grain. Leave to dry 2-3 hours in warm, dry well ventilated conditions.


A single application is recommended, followed by 2 coats of Fiddes Premier SP Floor Lacquer.

Cleaning & Maintenance

For regular light cleaning, a damp cloth should be applied and resulting clean area
left to dry. Periodically, an application of Fiddes Floor Surface Cleaner is recommended.


8-10 sqm per litre at 120-100g/m2 per coat




Always test intercoat adhesion prior to major application.
Longer drying periods may occur in cold, damp or humid conditions.
Allow 24 Hours before use. Full curing in 7 days.
Store in frost free area.



You may also like…